Siganor
Contact
← Siganor Learn

Build a seal-in circuit with Start and Stop

A momentary Start button cannot hold a motor on by itself. This video adds a seal-in branch, a Motor contact in parallel with Start, so the rung latches, and a normally closed Stop breaks it. A second rung drives a run lamp from the same Motor bit.

Seal-in

Keep a motor running after Start is released: a Motor contact in parallel with Start, a normally closed Stop, and a run lamp.

  1. 0:07Open the seal-in lesson
  2. 0:13Release Start: the motor keeps running
  3. 0:52Add and open a rung
  4. 0:59Build the parallel branch
  5. 1:13Add Stop and the Motor coil
  6. 1:29Add the pilot light rung
  7. 1:39Start released: both outputs at 1
  8. 1:50After Stop: both outputs at 0

What you’ll learn

  • Latch an output with a seal-in branch: an output contact in parallel with the start input.
  • Break the circuit with a normally closed Stop contact.
  • Drive a second output (a run lamp) from the same latched bit.