Siganor
Contact
← Siganor Learn

Delay an output with a TON timer

A TON timer counts while its input is on and resets when it turns off. This video wires Heater_On into a TON named Fan_Delay with a five-second preset, then uses its .DN bit to turn on a fan once the delay finishes.

TON · On-delay timer

Program a five-second TON to start a fan after the heater switches on.

  1. 0:00TON Timer
  2. 0:10A fan with a start delay
  3. 0:19LADDER · THE DN BIT STARTS THE FAN
  4. 0:44Open the timers lesson in Siganor Learn
  5. 0:47Make sure Edits On is active
  6. 0:50Double-click the empty rung
  7. 0:53In Bit, click XIC
  8. 0:56Enter Heater_On
  9. 0:59Open Timer / Counter
  10. 1:02Click TON
  11. 1:05In Timer, enter Fan_Delay
  12. 1:09Preset = 5000 ms · Accum = 0
  13. 1:14Click Accept to save
  14. 1:17Click + to add the second rung
  15. 1:20Open the rung and return to Bit
  16. 1:23Insert XIC with Fan_Delay.DN
  17. 1:27Click OTE
  18. 1:30Enter Fan
  19. 1:33Click Accept to save
  20. 1:36Click Run
  21. 1:39Open Simulator in the organizer
  22. 1:42Turn on Heater_On · TON starts timing
  23. 1:47ACC reaches 5000 · DN = 1 · Fan = 1
  24. 1:52Turn off Heater_On · ACC and Fan return to 0
  25. 1:57Try the TON in Siganor Learn

What you’ll learn

  • Start a TON timer from an input contact (XIC).
  • Set a timer's preset in milliseconds.
  • Use a timer's .DN bit to drive an output once it finishes counting.